Orthostand.
Orthostand One.
Orthostand One is equipped with a safe electrically height-adjustable platform with a particularly low step of 14 cm with solid rotating safety bars.
The Lift Module is powered by two powerful motors. The system has an enormous lifting capacity, but for safety it is limited to 140 kg because heavy people often experience problems with balance.
Orthostand has developed a device that allows foot specialists to work more productively and comfortably during treating foot problems.
These swivelling safety bars can be secured in the following positions: step-up, standard support position or a more closed position for small people. There is also a transport position for the safety bars with which the Orthostand can be easily moved.
Notebook holder
Can be equipped with a Notebook holder.
Safe step up
Step up most safely from the sides.
Widely accessible
Standard and small-people position.
General
• Length: 98cm, Width: 88 cm Including safety bars and overhanging back support
• Width when single safety bar open: 128 cm
• Floor contact: 77.5 cm wide x 80 cm deep
Seat
• Width: 44 cm, Depth: 43 cm, seat height standard: 41.5 cm
• The Seat is fixed at 440mm from the Platform. As an option we will develop an Electric Height adjustable seat that will be adjustable between 395 and 515 cm.
Platform
• Width: 70 cm, Depth: 56 cm
• Minimum step-up height: 13 cm, max. height platform: 54 cm
• Maximum platform height at system setting +5cm: 58 cm and at position +10 cm: 63 cm
Height of Safety Bars Relative to the Platform
• Height of bars: 110 cm
Weight
• Product: 65 kg
• Loadable weight: 140 kg
System Positions
• If an accessory is placed under the platform, the entire platform and seat must be adjusted in height by 5 cm or 10 cm. This also increases the maximum height of the device by 5 or 10 cm.
Required Minimum Height of the Practitioner's Workspace is 250 cm
• The height of the workspace minus 53 cm in standard position is the maximum length for a client.
With a Client Height of 195 cm, The Minimum Height of the Room is 250 cm
• If the system position is set to +5 cm this becomes 255 cm and in system position +10 cm it becomes 260 cm.
Options
• Sensor module with horizontal sliding possibility for line
Slider module for Third Parties
• Slider module for footbed or scanner on top of the platform
(under development)
Slider Module (in development)
The slider module that is attached to the System frame is a kind of drawer for equipment on which clients are analyzed while standing up. In use, the tray rests on the platform. To use the Platform, the slider is pushed back.
Sensors module offers horizontal shifting capabilities for 3rd party line lasers.
Slider module set backwards
Slider module set backwards
Slider module set forward in action